室温铁磁性Sr3YCo4O10.5+δ多晶有序化的烧结工艺及电磁性能

采用固相反应法制备了不同烧结温度(950~1 180 ℃)、烧结时间、烧结次数共7种工艺的Sr₃YCo₄O_10.5+δ多晶块材,通过热分析、XRD、SEM确定了有序化相变和最佳烧结工艺(1 180 ℃/24 h+1 180 ℃/24 h),并研究了多晶的电磁性能。结果表明,964 ℃完全晶化的四方相Sr₃YCo₄O_10.5在1 042 ℃吸氧(δ)完成有序化,生成Sr₃YCo₄O_10.5+δ,而1 100 ℃和1 180 ℃烧结的样品均出现(103)、(215)超结构峰,验证了其结构的有序性。块材均呈半导体电输运行为,二次烧结晶格完整性提高,晶粒长大,300 K时电阻率仅为0.06 Ω·cm,居里温度(T_c)~335 K,零场冷曲线(ZFC)上的Hopkinson峰源于低温时被冻结的磁矩随温度升高转向磁场方向,磁化强度在298 K达到最大,随后受热扰动的影响减小。室温铁磁性源于有序结构导致的中自旋或高自旋态Co³⁺的e_g轨道有序。     

Sensitivity analysis of thermal performances of flat plate solar air heaters

Sensitivity analysis is a mathematical tool, first developed for optimization methods, which aim is to characterize a system response through the variations of its output parameters following modifications imposed on the input parameters of the system. Such an analysis may quickly become laborious when the thermal model under consideration is complex or the number of input parameters is high. In this paper, we develop a mathematical model to analyse the heat exchanges in four different types of solar air collectors. When building this thermal model we show that for each collector, at quasi-steady state, the energy balance equations of the components of the collector cascade into a single first-order non-linear differential equation that is able to predict the thermal behaviour of the collector. Our heat transfer model clearly demonstrates the existence of an important dimensionless parameter, referred to as the thermal performance factor of the collector, that compares the useful thermal energy which can be extracted from the heater to the overall thermal losses of that collector for a given set of input parameters. A sensitivity analysis of our thermal model has been performed for the most significant input parameters such as the incident solar irradiation, the inlet fluid temperature, the air mass flow rate, the depth of the fluid channel, the number and nature of the transparent covers in order to measure the impact of each of these parameters on our model. An important result which can be drawn from this study is that the heat transfer model developed is robust enough to be used for thermal design studies of most known flat plate solar air heaters, but also of flat plate solar water collectors and linear solar concentrators.     

Comparative studies on the mechanism of uridine phosphorolysis

We have used quantum mechanical method to study the transition states(TSs) of uridine phosphorolysis reaction. Comparing the four different reaction pathways and the five transition states obtained, we conclude that enzymatic uridine phosphorolysis takes place mainly according to acid-catalyzed SN2 mechanism. The proposed reaction pathway is consistent with many experimental results.     

Schwinger boson mapping of SO(8) fermion model

The Schwinger representation of the SO(8) fermion pair algebra in terms ofd and quasispin vector (u, s, v) bosons is used in deriving a microscopic boson coherent state having both particle-hole and pair excitations. The coherent state is the exact boson image of the HFB variational solution. We can study the shape phase transition and pairing behaviour of the nuclear ground states using the coherent states.     

部分相干电磁光束在湍流介质中传输的偏振变化

 从推广的惠更斯-菲涅尔原理出发，推导出了部分相干电磁光束的偏振态在湍流介质中传输的表达式。并以电磁高斯-谢尔模型(EGSM)光束为例，研究了湍流对电磁高斯-谢尔模型光束偏振态的影响。研究结果表明，对于轴上点，湍流介质的折射率结构常数越大，偏振度趋于最大值的速度越快，达到的最大值越小；光斑越大，偏振度达到最大值的位置离光源越远，在光斑增大的过程中，偏振度所达到的极大值会先增大后减小，最后保持与光源相同的偏振度不变。对于轴外点，一个固定的z，光的偏振度随着离轴距离的增大而逐渐下降，并最终等于零。折射率结构常数越大，偏振度随离轴距离的增大而下降得越缓慢；光斑越大，偏振度随离轴距离的增大下降得越快。     

机载稳瞄控制系统模型及仿真分析

瞄准线高精度稳定是机载光电稳瞄系统的主要指标和关键技术。根据四框架稳瞄系统的工作原理，以手动跟踪模式为主要研究对象，建立了稳瞄伺服控制系统模型。考虑到直升机扰动特点，对线扰动、角速率扰动、摩擦力矩、弹性力矩等各种扰动因素也建立相应的数学模型，同时在各种扰动因素作用下利用Matlab对机载高精度稳瞄系统的手动跟踪控制模式进行了仿真设计分析和理论研究，设计出适合的控制器。此模型在实际系统中获得验证，对稳瞄伺服控制系统的设计具有参考意义。     

Dominant modes of submerged thin cylindrical shells

The relationship between the dominant mode of the submerged thin cylindrical shell and the flexural wave velocity is investigated. The natural frequency corresponding to the vibration mode is obtained as the solution of characteristic equation of thin cylindrical shell. However, it is difficult to estimate the dominant mode, especially if two or more vibration modes are involved. To estimate the dominant mode of a thin shell in vacuo, the concept of “modified bending stiffness” has been introduced. In this paper, the concept of modified bending stiffness is extended to estimate the dominant mode of a submerged thin cylindrical shell. The dominant mode of a submerged thin cylindrical shell is theoretically discriminated from the other mode based on the smallness of the modified bending stiffness of the submerged shell. The validity of our theory is confirmed by a good agreement between theoretical and experimental results on flexural wave velocity.     

《光谱学与光谱分析》2007年征订启事

The authors achieved the temporal coherent control in an Er^3＋ doped telluride glass, one kind of disordered solids. The upconversion at 670 nm was modulated and the dephasing time was simulated as 300 fs. Moreover, the photon echo signal gave the dephasing time due to the phonon interaction. The agreement between the two data indicates that the interaction between the wavepacket and the phonon leads to the fast disappearance of wavepackets interference, which is helpful for the tech- nique to be applied to the disordered solids.     

分布函数在容器壁上的取值以及由此引起的问题

普遍认为分布函数f在容器壁上的取值为零,如果情况确实如此,则平衡分布函数在容器壁上将不连续,从而会产生不合理的结果.分析指出了在证明H定理时不应假定f在容器壁上为零.     

基于Terminal滑模的有限时间混沌同步实现

提出了混沌同步有限时间实现问题，将Terminal滑模控制技术与混沌同步问题相结合，把同步问题视为响应系统的跟踪问题，给出了由线性滑模函数引入非线性项构造Terminal滑模面的充分条件，以及相应Terminal滑模控制器.以主从Duffing系统为例研究验证同步策略的可行性和有效性. 关键词： Terminal滑模 混沌同步 Duffing系统